Water still runs in both toilets after flushing? - best flushing toilets 2009
I replaced the whole unit in the toilet tank as a trap for the bathroom on the ground floor. I have nothing upstairs. After emptying the water is still running in the two bathrooms. The bathroom upstairs has a lever-type handle and pull the lower handle. The trick to stop the flow of water that is moving the handle and pull the rip-drive on the toilet. Sometimes you have to stop it once more thoroughly and then move the slider. The unit has been properly loaded in the bathtub. What is the problem?
Sunday, February 7, 2010
Best Flushing Toilets 2009 Water Still Runs In Both Toilets After Flushing?
Subscribe to:
Post Comments (Atom)
It seems that the case does not close properly and / or water is too high in the tank. What you need to install it did so to return and it is configured correctly. This is what you paid after all.
ReplyDeleteCheck the chain on the flush can try adjusting the length 1 The lid is not tightly closed, to see if there the deposit of limestone.
ReplyDeleteWipe the bottom of the case, you probably have mold in it.
ReplyDeleteThe trap is not properly seated .. to make a difference .. Sometimes it helps to soften the hands to the surface and his fingers around the opening of the hatch covers rub .. A deposit of little lime can not .. sounds like it is simply not correct in force ..
ReplyDeletePlug in the shell does not close the whole way. You need to settle. until it closes properly.
ReplyDelete